NETGEAR FVL328 Reference Manual page 61

The parameters are:
• Service — select the application or service to be allowed or blocked. The list already
displays many common services, but you are not limited to these choices. Use the Add
Services menu as seen in
not already appear.
• Action — choose how you would like this type of traffic to be handled. You can block or
allow always, or you can choose to block or allow according to the schedule you have
defined in the Schedule menu.
• LAN Users —
on their source LAN IP address. Select the desired option:
• Any: All IP addresses are covered by this rule.
• Address range: If this option is selected, you must enter the "Start" and "Finish" fields.
• Single address: Enter the required address in the "Start" fields.
• WAN Users —
based on their destination WAN IP address. Select the desired option:
• Any - All IP addresses are covered by this rule.
• Address range - If this option is selected, you must enter the "Start" and "Finish"
fields.
• Single address - Enter the required address in the "Start" fields.
• Log — select whether the traffic will be logged. The choices are:
• Never - No log entries will be made for this service.
• Always - Any traffic for this service type will be logged.
• Match - Traffic of this type which matches the parameters and action will be logged.
• Not match - Traffic of this type which does not match the parameters and action will
be logged.
Protecting Your Network
Model FVL328 ProSafe High-Speed VPN Firewall Reference Manual
Figure 5-3
these settings determine which packets are covered by the rule, based
these settings determine which packets are covered by the rule,
M-10144-01
to add any additional services or applications that do
5-11