Honeywell TB7200 Series Wireless Installation & Integration Reference Manual page 16

WIRELESS INSTALLATION & INTEGRATION REFERENCE GUIDE FOR TB7200/TB7300/TB7600 SERIES THERMOSTATS
4. The Status field at the top of the Property Sheet should display (ok). This means your wireless card on the controller is
recognized.
5. Click on the Save button to save your settings and to properly start the network.
As soon as a valid PAN ID and Channel are given to the WEBs-AX controller's wireless communication card, any thermo-
stat having the same configuration of PAN ID and Channel can be detected and registered to the wireless card.
MORE INFORMATION ON THE WIRELESS NETWORK PROPERTY SHEET
This section provides additional information on the Wireless Network Property Sheet.
ZigBee PAN ID: (Personal Area Network Identification ). This is where the PAN ID of the gateway is set. Range is from address 1
to 500. The default of "0" is not a valid PAN ID.
ZigBee Channel: This is where the current Channel frequency used by the wireless thermostat network is set. While the range is
from 11 to 26 ( 2405 MHz to 2480 MHz, 5 MHz channel spacing), use only Channel 15 or 25. Please note that channel 26 is
attenuated by 4 db compared to the other channels. The default of "10" is not a valid Channel. 802.11 Wi-Fi transmissions
overlap and may interfere with other channel selections allowed by 802.15.
ZigBee Address: Individual unique ZigBee address for any ZigBee device on a ZigBee network. The address is assigned during
the initial network start-up and is saved in flash memory. This is the main address used for all key low level network functions.
The communication module information and the assigned IEEE and ZigBee wireless address information are given for
information references only.
Any time the PAN ID or Channel is changed, a new ZigBee address is assigned by the network manager to the devices.
IEEE Address: Individual unique IEEE address for any ZigBee device on the network. Factory assigned and non-editable.
63-4522—02 16