Mounting Of Handle For Em4340L - Makita EM4341 Instruction Manual

MOUNTING OF HANDLE FOR EM4340L

CAUTION: Before doing any work on the brush cutter, always stop the engine
and pull the spark plug connector off the spark plug.
Always wear protective gloves!
CAUTION: Start the brush cutter only after having assembled it completely.
– Place the handle with throttle lever on the handle holder in such a manner
that it will be on the right side (to be held by the right hand) viewed from the
engine side.
– Provisionally fix the upper side of the handle holder with the attached bolt (1).
– Adjust the handle to an angle easy to manipulate, and fix it by the bolt.
– Fix the control cable by three clips (2).
Note: If the control cable is not kept tight, it may be caught by a twig, leading
to an accident.
8
(1)
Clips (2)