Rear - Makita EM4341 Instruction Manual

For EM4341
– Fit the handle edge to the handle holder groove, and provisionally fix the
upper side (3) of the handle holder by four bolts M5 x 25 (4).
– Adjust the handle to an angle easy to manipulate, and tighten the bolt (4)
uniformly on the right and left sides.
Note: Handle mounting position.
– Pass the control cable (6) through the rear grip (7) and insert tube (8) in the
control cable (6).
– Fix the control cable to the handle and shaft by two clamps.
Note: If the control cable is not tight, it may be caught by a twig, leading to an
accident.
Lay out the control cable as indicated in the figure.
Note: If the control cable is not tight, it may be caught by a twig, leading to an
accident.
10
(4)
(3)
to engine
(6)
(8)
(7)