Makita 5007MG Instruction Manual page 8

1. Switch trigger
1. Lamp
ASSEMBLY
1
2
1. Hex wrench
2. Protrusion
1
1. Hex wrench
2. Shaft lock
8
Switch action
007329
1
CAUTION:
• Before plugging in the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release the switch trigger to
stop.
Lighting the lamp
007351
CAUTION:
• Do not apply impact to the lamp, which may cause damage or shorted
1
service time to it.
• Do not look in the light or see the source of light directly.
The lamp lights up when the tool is plugged. The lamp keeps on lighting until
the tool is unplugged.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to
scratch the lens of lamp, or it may lower the illumination.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Hex wrench storage
007331
Hex wrench is stored on the tool. To remove hex wrench, rotate it toward your-
self and pull it out.
To install hex wrench, place it on the handle and turn it until it comes into con-
tact with the protrusion on the handle.
Removing or installing saw blade
007330
CAUTION:
• Be sure the blade is installed with teeth pointing up at the front of the
tool.
• Use only the Makita wrench to install or remove the blade.
To remove the blade, press the shaft lock so that the blade cannot revolve and
use the hex wrench to loosen the hex bolt counterclockwise. Then remove the
2
hex bolt, outer flange and blade.