Maintenance - Makita 5007MG Instruction Manual

MAINTENANCE

2
1
1. Base
2. Adjusting screw
1
1. Triangular rule
1. Limit mark
1
2
1. Brush holder cap
2. Screwdriver
10
CAUTION:
• Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
Adjusting for accuracy of 90° cut (vertical cut)
This adjustment has been made at the factory. But if it is off, adjust the adjust-
007332
ing screw with a hex wrench while squaring the blade with the base using a tri-
angular rule, try square, etc.
007333
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark. Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the same time. Use only
identical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
007334
brushes, insert the new ones and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized or Factory
Service Centers, always using Makita replacement parts.