Makita 3601B Instruction Manual page 7

1 2
4
3
1. Wing bolt (B)
2. Wing bolt (A)
3. Straight guide
4. Guide bar
1
1. Base plate
2. Templet guide
Straight guide
005043
The straight guide is effectively used for straight cuts when chamfering or
grooving.
To install the straight guide, insert the guide bar into the holes in the tool base
005044
until the notch in the guide bar reaches just under the wing bolt (B). Then
tighten wing bolt (B). Loosen the wing bolt (A) and adjust the distance between
the bit and the straight guide. At the desired distance, tighten the wing bolt (A)
to secure the straight guide in place.
When cutting, move the tool with the straight guide flush with the side of the
workpiece.
Templet guide (Accessory)
005045
The templet guide provides a sleeve through which the bit passes, allowing
use of the tool with templet patterns.
To install the templet guide, screw the templet guide on the base plate.
005046
2
7