Makita 3601B Instruction Manual page 11

2
1. Brush holder cap
2. Screwdriver
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita service center.
• Straight & groove forming bits
• Edge forming bits
• Laminate trimming bits
• Straight guide assembly
• Trimmer guide assembly
• Templet guide 25
• Templet guides
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
005050
brushes, insert the new ones and secure the brush holder caps.
Then install the rear cover with the screws.
1
CAUTION:
• Do not turn the tool on without the rear cover installed in place.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
ers, always using Makita replacement parts.
• Templet guide adapter
• Lock nut
• Collet cone 12 mm, 1/2"
• Collet sleeve 3/8", 1/4"
• Collet sleeve 6 mm, 8 mm, 10 mm
• Wrench 21
• Wrench 23
11