Page 1
Router MODEL 3601B 005038 DOUBLE INSULATION I N S T R U C T I O N M A N U A L WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
Standard and can, therefore, also be used from sockets accordance with Council Directives, 73/23/EEC, 89/336/ without earth wire. EEC, 98/37/EC. Yasuhiko Kanzaki CE 2004 Director MAKITA INTERNATIONAL EUROPE LTD. Michigan Drive, Tongwell, Milton Keynes, Bucks MK15 8JD, ENGLAND Responsible manufacturer: Makita Corporation Anjo Aichi Japan...
SAFETY INSTRUCTIONS ENA001-2 WARNING: When using electric tools, basic safety precautions, including the following, should always be followed to reduce the risk of fire, electric shock and personal injury. Read all these instructions before operating this product and save these instructions. For safe operations: tion and changing accessories.
ADDITIONAL SAFETY RULES ENB033-2 10. Be careful of the bit rotating direction and the Hold tool by insulated gripping surfaces when performing an operation where the cutting tool feed direction. may contact hidden wiring or its own cord. Con- 11. Do not leave the tool running. Operate the tool tact with a “live”...
FUNCTIONAL CAUTION: DESCRIPTION • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Adjusting the depth of cut 005039 Place the tool on a flat surface. Turn the scale ring until it makes contact with the base.
ASSEMBLY CAUTION: • Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. Installing or removing the bit 005042 CAUTION: • Install the bit securely. Always use only the wrenches provided with the tool.
Page 7
Straight guide 005043 The straight guide is effectively used for straight cuts when chamfering or grooving. To install the straight guide, insert the guide bar into the holes in the tool base 005044 until the notch in the guide bar reaches just under the wing bolt (B). Then tighten wing bolt (B).
Page 8
Secure the templet to the workpiece. Place the tool on the templet and move 003695 the tool with the templet guide sliding along the side of the templet. NOTE: • The workpiece will be cut a slightly different size from the templet. Allow for the distance (X) between the bit and the outside of the templet guide.
Page 9
When cutting, move the tool with the guide roller riding the side of the work- 003701 piece. 1. Bit 2. Guide roller 3. Workpiece Connecting a vacuum cleaner 006286 Connect a vacuum hose to the tool and further connect another end of it to the vacuum cleaner.
Connect another and of the hose to the vacuum cleaner hose of 38 mm in 006288 inner diameter using a joint. 1. Hose 2. Joint 3. Vacuum hose 4. Outer diameter ø32 mm 5. Inner diameter ø38 mm MAINTENANCE CAUTION: •...
Page 11
CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
Page 12
Makita Corporation Anjo, Aichi, Japan 883011A224...