Makita 3707 Instruction Manual page 8

1
2
3
4
5
6
1. Bolt
2. Guide plate
3. Straight guide
4. Flat washer
5. Wave washer
6. Wing nut
1
2
3
1. Clamp screw (A)
2. Straight guide
3. Wing nut
4. Base
(A)
8
Attach the guide plate to the straight guide with the bolt, the wave washer, the
001990
flat washer and the wing nut.
Attach the straight guide with the clamp screw (A). Loosen the wing nut on the
001708
straight guide and adjust the distance between the bit and the straight guide.
At the desired distance, tighten the wing nut securely.
When cutting, move the tool with the straight guide flush with the side of the
workpiece.
4
If the distance (A) between the side of the workpiece and the cutting position is
001709
too wide for the straight guide, or if the side of the workpiece is not straight, the
straight guide cannot be used. In this case, firmly clamp a straight board to the
workpiece and use it as a guide against the trimmer base. Feed the tool in the
direction of the arrow.