Maintenance - Makita 3707 Instruction Manual

1
2
3
1. Adjusting screw
2. Clamp screw (B)
3. Trimmer guide
4. Clamp screw (A)
1
1. Workpiece
2. Bit
3. Guide roller

MAINTENANCE

1. Limit mark
10
Trimmer guide
001713
Trimming, curved cuts in veneers for furniture and the like can be done easily
with the trimmer guide. The guide roller rides the curve and assures a fine cut.
Install the trimmer guide on the tool base with the clamp screw (A). Loosen the
001714
clamp screw (B) and adjust the distance between the bit and the trimmer guide
by turning the adjusting screw (1 mm per turn). At the desired distance, tighten
the clamp screw (B) to secure the trimmer guide in place.
4
When cutting, move the tool with the guide roller riding the side of the work-
001998
piece.
2
3
CAUTION:
• Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark. Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the same time. Use only
identical carbon brushes.
1