Maintenance - Makita 3612C Instruction Manual

MAINTENANCE

1. Limit mark
2
1
1. Brush holder cap
2. Knob
3. Screwdriver
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita service center.
• Straight & groove forming bits
• Edge forming bits
• Laminate trimming bits
• Straight guide
• Trimmer guide
• Guide holder
• Templet guides
• Templet guide adapter
CAUTION:
• Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark. Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the same time. Use only
identical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
003702
brushes, insert the new ones and secure the brush holder caps.
NOTE:
3
• When replacing carbon brush located on the same side as the knob,
remove the knob first before unscrewing the brush holder cap.
CAUTION:
• Be sure to re-install the knob after inserting new carbon brush.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
ers, always using Makita replacement parts.
• Lock nut
• Collet cone 12 mm, 1/2"
• Collet sleeve 6 mm, 8 mm, 10 mm
• Collet sleeve 3/8", 1/4"
• Wrench 8
• Wrench 24
• Vacuum head set
13