Makita 3612C Instruction Manual page 10

1
2
3
4
5
6
1. Bit
2. Base
3. Templet
4. Workpiece
5. Distance (X)
6. Outside diameter of the templet
guide
7. Templet guide
1
2
3
4
5
1. Wing bolt (A)
2. Guide holder
3. Fine adjusting screw
4. Wing bolt (B)
5. Wing bolt (C)
6. Trimmer guide
7. Guide roller
10
Secure the templet to the workpiece. Place the tool on the templet and move
003695
the tool with the templet guide sliding along the side of the templet.
7
NOTE:
• The workpiece will be cut a slightly different size from the templet. Allow
for the distance (X) between the bit and the outside of the templet guide.
The distance (X) can be calculated by using the following equation:
Distance (X) = (outside diameter of the templet guide - bit diameter) / 2
Trimmer guide (optional accessory)
003698
Trimming, curved cuts in veneers for furniture and the like can be done easily
with the trimmer guide. The guide roller rides the curve and assures a fine cut.
Install the trimmer guide on the guide holder with the wing bolt (B). Insert the
003700
guide holder into the holes in the tool base and tighten the wing bolt (A). To
adjust the distance between the bit and the trimmer guide, loosen the wing bolt
(B) and turn the fine adjusting screw (1.5 mm per turn). When adjusting the
guide roller up or down, loosen the wing bolt (C). After adjusting, tighten all the
wing bolts securely.
7
6