Leveling - Maytag MLE20PRBZW1 Installation Instructions Manual

ELECTRIC DRYER ELECTRICAL CONNECTIONS
Connecting 3-Wire Connection: Optional
Use for direct wire or power supply cord where local codes
do not permit connecting cabinet-ground conductor to
neutral wire.
Connecting Neutral Wire
1. Remove center terminal block screw. Also remove neutral
ground wire by removing external ground conductor screw.
3. Connect remaining wires to outer terminal block.
2. Connect neutral wire and neutral wire of power supply cord/
cable to center terminal block.
4. Connect a separate copper ground wire from the external
ground conductor to an adequate ground.
Leveling Stacked Washer/Dryer
Leveling your washer/dryer properly reduces excess noise and
v bration.
Excessive Weight Hazard
Use two or more people to move and install washer/dryer.
Failure to do so can result in back or other injury.
LEVELING
1. Remove cardboard from beneath washer/dryer. Place a level
on top edges of washer/dryer, checking each side and front.
If not level, tip washer/dryer and adjust feet up or down as
shown in Steps 3 and 4, repeating as necessary.
Not Level LEVEL Not Level
27