Remote Phone Control Commands
Enter User Code (within eight seconds). Upon entering remote phone control mode the Lynx will
announce "System, enter code".
To remotely disarm system:........................................................... User Code + [1]
To remotely arm in AWAY mode: .................................................. User Code + [2]
To remotely arm in STAY mode: ................................................... User Code + [3]
To remotely arm in AWAY or STAY mode with no delay:.............. User Code + [2] or [3] + [0]
To remotely Bypass zones: ........................................................... User Code + [6] + zone no.
To remotely activate Forced Bypass: ............................................ User Code + [6] + [#]
To remotely check system status:.................................................. [✻]
To end remote phone session: Hang Up or ................................. User Code + [9]
Notes: (1) Check with your installer to see if the Forced Bypass mode has been enabled.
(2) When bypassing zones, make sure a confirmation beep sounds for each zone that has been
bypassed.
Remote Phone Control Feature
– 58 –
USER FUNCTIONS
USER FUNCTIONS
USER FUNCTIONS
USER FUNCTIONS