Section 4: Operations; Operation Safety; Basic Use And Care - Grizzly Power Feeder G4181 Owner's Manual

SEctiON 4: OPERatiONS

Operation Safety

to reduce the risk of
serious injury when using
this machine, read and
understand
manual before beginning
any operations.
Damage to your eyes and lungs could result
from using woodworking machinery without
proper protective gear. always wear safety
glasses and a respirator when operating this
machine.
Loose hair, clothing, or
jewelry could get caught
in machinery and cause
serious personal injury.
Keep these items away
from moving parts at all
times to reduce this risk.
NOTICE
if you have never used this type of machine
or equipment before, WE StRONGLy REc-
OMMEND that you read books, trade maga-
zines, or get formal training before begin-
ning any projects. Regardless of the con-
tent in this section, Grizzly industrial will
not be held liable for accidents caused by
lack of training.
-18-

basic use and care

you MuSt assemble all guards, fences,
and hold-downs before starting your
machine or power feeder. Failure to heed
this entire
this warning could result in amputation or
death!
power feeders reduce kickback hazards and
improve cutting results by feeding in a consistent
and stable manner. remember, do not to stand in
the path of potential kickback. When not in use,
support the power feeder with a wooden block so
the rubber wheels are raised above the table and
do not compress from the weight of the power
feeder.
the universal joints on this power feeder allow
you to adjust the power feeder tracking and height
to accommodate many workpiece sizes. Before
loosening any lock lever, always support the
power feeder with a block of wood, so the power
feeder does not drop and cause damage.
adjust the power feeder so it is toed-in approxi-
mately 1° to 1.5° degrees towards the machine
fence. this adjustment will ensure that the power
feeder wheels slightly push the workpiece against
the fence during cutting operations (Figure 8).
next, adjust the power feeder so the rubber
wheels are parallel with the table surface, and are
⁄
1
8
this adjustment ensures that the workpiece will
not slip or hang in the middle of a cut. always
double check that the power feeder wheels are
slightly lower than the workpiece before you begin
feeding operations. otherwise, the workpiece
may slip and kickback.
lower than the thickness of your workpiece.
"
Model g4181/g7873 1-hp power Feeder