Back Panel Connectors, Buttons, And Switches - NETGEAR WNHD3004 User Manual

Back Panel Connectors, Buttons, and Switches

This illustration identifies the connectors and switches on the back of the unit.
Power connector
Figure 1-2
Table 1-1. Connectors and Buttons
Connector or Button
Power connector
Four Mbps Ethernet ports
Factory default reset button
Mode switch settings
On/Off button
Getting Started
3DHD Home Theater Adapter WNHD3004 User Manual
On/Off button
Ethernet Ports
Description
Port for connecting the AC power adapter.
For connecting the unit using Ethernet cables to other equipment like
switches, game consoles, media adapters, print servers, or a router.
Use a paper clip to press this button for about 10 seconds to reset the
unit to its factory default settings.
• Auto. Auto is the factory default setting. In Auto mode, if the unit
senses it is connected to a router or gateway, it automatically sets
itself to run as an AP. Otherwise, if connected to any other wired
device, the unit automatically sets itself to run in Bridge mode.
• AP. When switched to AP (access point) mode, the unit acts as an
access point. In this mode, connect it to a router. The free Ethernet
port can be used to connect other equipment to your network using
an Ethernet cable.
• Bridge. In Bridge mode, connect devices to the unit using Ethernet
cables and they will connect to your wireless network. Typically,
when a unit is set to bridge mode, it is paired with a WNHD3004
working in AP mode.
Press this button to turn the WNHD3004 on or off.
v1.0, November 2010
Factory Reset Settings
1-3