Grizzly G5960 Instruction Manual page 10

Removal of 5-C
Collet
To remove or replace your 5-C collet in the
collet closer assembly:
Choose a 5-C collet that is suitable for the
1.
intended stock size to be turned.
Disengage the hub locking pin so the flat is
2.
turned toward the outer rim of the hub
adapter as shown in Figure 15.
Pin Disengaged
Pin
Engaged
Figure 15. Locking pin positions.
Rotate the draw tube counter-clockwise at
3.
the end of the collet closer (Figure 16) to
unthread the collet.
The draw tube threads may be sharp. To
avoid cutting your hands, use a clean rag
to rotate the draw tube.
Remove the collet from the collet adapter
4.
and insert the new 5-C collet.
Rotate the draw tube clockwise at the end of
5.
the collet closer to engage the new collet
threads.
Engage the hub locking pin back into place
6.
as shown in Figure 15.
-8-
Figure 16. Location to rotate draw tube to
remove or replace 5-C collets.
Installing 5-C Collet
To adjust your 5-C collet in the collet closer
assembly:
Choose a 5-C collet that is suitable for the
1.
intended stock size to be turned.
Line up the collet keyway with the collet
2.
adapter pin and insert the collet until it stops,
then gently rotate it for final alignment.
Gently push on the end of the draw tube until
3.
it engages the collet threads in the spindle,
and rotate the adjusting hub in a clockwise
fashion (as viewed from the outboard end of
the lathe in Figure 8).
— If the draw tube fails to touch the collet,
remove the collet and look into the spindle to
see if the draw tube is accessible for proper
engagement. If the collet cannot touch the
draw tube when inserted into the spindle, see
the following section on "Rough Adjustment."
If the collet does reach, try again to thread
the collet and adapter into the spindle by fol-
lowing the guidelines in the "Tube Assembly"
sub-section of this manual.
G8143 Collet Closer