Grizzly G1026 User Manual

G1705 & G1794 Router Bit Spindle
To install the router bit spindle, proceed as follows:
1. Remove existing spindle from the shaper by holding the top of the spindle with a wrench and
remove the tie rod nut from the bottom of the spindle housing. Figure 2. Pull the spindle out of
the spindle cartridge. Notice that the bottom portion of the spindle is identical to the bottom por-
tion of the router bit spindle.
1 ⁄ '' TO 1 ⁄ '' Adapter
2 4
Collet Nut
Figure 1. Router Bit Spindle.
4. Place a router bit into the router bit spindle and
tighten the collet nut.
Caution: Do not run the router bit spindle in reverse
direction (clockwise if you look down on the spidle).This
can cause the collet nut to loosen, allowing the router bit
to come out.
© Grizzly Industrial, Inc. 1996
For The G1035 & G1026 Shapers
2. Unthread the tie rod from
the spindle and completely
thread into the bottom of the
router bit spindle.
3. Place the router bit spindle
into the spindle housing and
line up the pin with the key-
way. Figure 3. Tighten the
tie rod nut to secure. Use a
back-up wrench on the
router bit spindle while tight-
ening the tie rod nut. Figure 2. Draw Bar & Nut.
Keyway
Router Bit Spindle
Spindle Cartridge
Pin
Spindle Housing
Figure 3. Inserting Router Bit Spindle.
®
Tie Rod
Tie Rod Nut