Restoring The Default Settings - NETGEAR RangeMax WPN824v3 User Manual

Table A-2. wireless router Default Configuration Settings (continued)
Feature
Transmission speed
Authentication type
Country/Region
RF channel
Operating mode
Data rate
Output power
a. Maximum wireless signal rate derived from IEEE Standard 802.11 specifications. Actual throughput will
vary. Network conditions and environmental factors, including volume of network traffic, building
materials and construction, and network overhead, lower actual data throughput rate.

Restoring the Default Settings

You can restore the factory default configuration settings to reset the router's user name to admin,
the password to password, and the IP address to 192.168.1.1. This procedure erases your current
configuration, including your wireless security settings, and restores the factory defaults. When
you log in after resetting, the Smart Wizard configuration assistant prompts you to configure these
settings.
To restore the factory default configuration settings:
1. Use a sharp object such as a pen or a paper clip to press and hold the restore factory settings
button, located on the rear panel of the router, for about 10 seconds.
2. Release the restore factory settings button, and wait for the router to reboot.
The factory default settings are restored so that you can access the router from your Web
browser using the factory defaults.
Technical Specifications and Default Configuration Settings
RangeMax Wireless Router WPN824v3 User Manual
Default Setting
a
Auto
Automatic
United States in the U.S., otherwise varies by region
06
Auto 108 Mbps
Best
Full
v1.0, January 2008
A-3