Deactivating The Detector; Confidence Beep - Honeywell GasAlert Extreme User Manual

GasAlert Extreme
User Manual

Deactivating the Detector

If Deactivation Passcode Protection is enabled, the detector
cannot be disabled without entering a passcode first. PASS
displays immediately after OFF, refer to
Protection. This option can only be enabled at the factory and
cannot be disabled by the customer.
To deactivate the detector, complete the following:
A
1. Press and hold until OFF displays (approximately 5 seconds).
2. The detector beeps and vibrates four times, the LEDs flash four
times, and then the detector deactivates.
A
If is not held down until OFF displays, the detector will
remain activated.
13
Note
Deactivation Passcode
Note

Confidence Beep

The confidence beep provides continuous confirmation that the detector
is operating properly. When the confidence beep is enabled, the detector
beeps every 5 seconds.
The confidence beep can be enabled or disabled during start-up.
The detector is shipped with the confidence beep disabled.
Enabling the confidence beep decreases battery life.
To enable/disable the confidence beep, complete the following:
1. Ensure the detector is deactivated.
C
2. Press and hold . While holding
When the confidence beep option is enabled, the detector auto-
matically begins beeping when activated.
When the confidence beep option is enabled in stealth mode, the
detector vibrates one time every 60 seconds. For more informa-
tion refer to Stealth Mode Option
If confidence beep is enabled and a low battery alarm occurs,
the confidence beep deactivates.
Note
C A
, press .
and Alarms.
Note