Step 10, Slide Duct Cover Down; Step 11 Install Filters; Step 12 Install Rods - GE ZV421 Installation Instructions Manual

STEP 10 SLIDE DUCT COVER
DOWN
SKIP THIS STEP IF USING THE SUPPLIED DUCT
COVER
• Hold the duct cover in place and remove the
temporary stop screw. Return the screw to the
storage location for future use.
• Slide the lower duct cover down onto the hood.
Slide
Duct
Cover
Down
Storage Location

STEP 11 INSTALL FILTERS

• Place filter drip trays into the rear of the hood.
• Insert the filter into the upper opening and drop into
the trays.
• To remove the filters, grasp the knobs and push the
filter up and lift out.
Installation Instructions
Remove
Stop
Screw
Stop Screw

STEP 12 INSTALL RODS

• Use a flat blade screwdriver to install stand-offs into
the bottom of the hood.
• Align implement rod to stand-offs with the screw hole
towards the inside of the hood. Secure the rod to the
stand-offs with the supplied Allen wrench.
• Follow the same procedure on the opposite side.
17
Screw
Stand-offs
Into Hood
Use Allen
Wrench to
Secure Rod
to Stand-offs