Table of Contents
Advertisement
7
Cut a length of 6" duct to connect hood flange
to the ductwork.
Step
• Install ductwork, making connections in
Connect
• Secure joints in ductwork with sheetmetal
Ductwork
• Wrap joints with duct tape for airtight seal.
8
Verify that power is turned off at the source.
Step
Connect
Electrical
9
Step
Install the
Decorative
Duct Cover
Place the decorative duct cover on top of the
hood.
• Insert the lower portion of the duct cover
• Extend the inner duct upwards to meet the
• Secure the duct cover to the bracket with the
direction of airflow as illustrated.
screws.
CAUTION
WARNING
If house wiring is not 2-wire with a
ground wire, a ground must be
provided by the installer.
When house wiring is aluminum,
be sure to use U.L. approved anti-
oxidant compound and alumi-
num-to-copper connectors.
Mounting Screws
into the impression on the top of the hood.
ceiling and bracket.
2 small Phillips screws provided.
Installation
• Insert house wiring through strain relief and
tighten.
• Connect white leads to branch circuit white
lead.
• Connect black leads to branch circuit black
lead.
• Connect green/yellow leads to branch
circuit green or bare ground lead.
• Secure all connections with wire nuts on
each electrical connector.
• Push wires into junction box and replace
cover. Be sure wires are not pinched.
Bottom
Notches
Install Optional ZX10SY Duct Cover
• Separate the supplied duct cover into pieces.
Discard the upper (or inner) section.
• Insert the new ZX10SY duct cover into the
original lower section. Be sure that the new
longer section is inside the shorter original
section. The notches will be at the bottom
and the screw holes at the top as illustrated.
• Follow the same procedures shown above to
install the new duct cover.
36" Vent Hood
Duct Tape
Over Seam and Screw
Air
Flow
Screw
10
Advertisement
Table of Contents
