Step 5, Install Duct Transition And Damper; Step 6, Install Hood To Support; Step 7 Connect Duct - GE ZV421 Installation Instructions Manual

STEP 5 INSTALL DUCT TRANSITION
WITH DAMPER
Attachment
Screws
Screws C
IMPORTANT: Remove shipping tape from damper and
check that damper moves freely.
• Place the transition piece over the hood exhaust and
secure with 4 Screws C provided.
• Use duct tape to seal the connection. Check to be
sure the damper moves freely.
Installation Instructions
Bumper Pads
Duct
Transition
STEP 6 INSTALL HOOD
Note: THREE PEOPLE ARE REQUIRED TO
COMPLETE THIS INSTALLATION!
1/4" Gap
• Back out the hanging screws on the bottom of the
support frame to a 1/4" gap.
• Lift the hood up to the support frame. Carefully align
the hood keyhole to the screws on the support frame.
Slide the hood to engage the keyhole slots.
• Tighten the screws.
Screws C
• Install safety screws into the top of the hood as
shown.
• Check hood level in both directions.

STEP 7 CONNECT DUCT

• Loosen duct collar and slide
down to cover gap between
transition and house duct.
Tighten collar
screws and tape all joints.
• Seal all connections with duct
tape.
Note: Do not drive screws through this duct
connection. Doing so will prevent proper damper
operation.
15
Attachment
Keyholes
Install
2 Safety
Screws
Slide Duct
Slide Duct
Collar Down
Collar Down
to Cover Gap
to Cover Gap