Step 7: Connect Ductwork; Step 8: Connect Electrical; Step 9: Install Decorative Duct Cover And Utility Bars - GE Monogram ZV750 Installation Instructions Manual

7
Step
connection. Doing so will prevent proper
damper operation. Seal connection with
Connect
tape only.
Ductwork
• Install ductwork, making connections in
• Secure joints in ductwork with sheetmetal
• Wrap all duct joints with duct tape for
8
Verify that power is turned off at the source.
Step
CAUTION
Connect
Electrical
9
Step
Install
Decorative
Duct Cover
and
Utility
Bars
Place the decorative duct cover on top of
the hood.
• Insert the lower portion of the duct cover
• Extend the inner duct upwards to meet the
• Secure the duct cover to the bracket with
• Install the side utility bars as shown with
10
Do not use sheet metal
screws at hood flange
direction of airflow as illustrated.
screws.
airtight seal.
WARNING
If house wiring is not 2-wire with
a ground wire, a ground must be
provided by the installer.
When house wiring is aluminum,
be sure to use U.L. approved
anti-oxidant compound and
aluminum-to-copper connectors.
Mounting Screws
into the impression on the top of the hood.
ceiling and bracket.
the 2 small Phillips screws provided.
screws provided.
Installation
36" Vent Hood
Duct Tape
Over Seam
and Screw
• Insert house wiring through strain relief
and tighten.
• Connect white leads to branch circuit
white lead.
• Connect black leads to branch circuit
black lead.
• Connect green/yellow leads to branch
circuit green or bare ground lead.
• Secure all connections with wire nuts on
each electrical connector.
• Push wires into junction box and replace
cover. Be sure wires are not pinched.
Bottom
Notches
Install Optional ZX10SY Duct Cover
• Separate the supplied duct cover into
pieces. Discard the upper (or inner)
section.
• Insert the new ZX10SY duct cover into
the original lower section. Be sure that
the new longer section is inside the shorter
original section. The notches will be at the
bottom and the screw holes at the top as
illustrated.
• Follow the same procedures shown above
to install the new duct cover.
Screw
Air Flow