Connecting An Emergency Signal - Bosch INTEGRUS Installation And Operating Manual

INTEGRUS | Digital Infra-red Language Distribution System
en |
29
2.3.3

Connecting an emergency signal

To use the emergency signal function, a switch (normally-open) must be connected to the emergency switch connector. When
the switch is closed, the audio signal on the Aux-Right input is distributed to all output channels, overriding all other audio
inputs.
The Aux. Input mode of the transmitter must be set to 'Mono + Emergency' (see section 2.5.13).
Figure 2.10 Connecting an emergency signal
BOSCH Security Systems | February 2003