Audio May Be Interrupted When Changing The Configuration; Recording Stops When Connecting Usb Cable To The Cu; Error Bar During Login; Disabled Home/Back Button - Bosch CCS 1000 D Release Notes

CCS 1000 D Digital Discussion System Release Notes

4.6 Audio may be interrupted when changing the configuration

The following changes in the configuration may interrupt the audio:
•
Changing the individual microphone outputs
•
Changing the recorder setting

4.7 Recording stops when connecting USB cable to the CU

An active recording stops when the CU is connected to a PC via a USB cable.
Any new recording cannot be started while the CU is connected to the PC.

4.8 Error bar during login

User with 'Only manage' rights gets an error bar during logging.

4.9 Disabled home/back button

Issue:
When saving the change in the 'date and time settings' the Home and Back icons in the bottom
bar are disabled.
Solution:
Clicking on 'Change date and time settings' again and selecting Cancel.

4.10 Downgrade error

Issue:
When downgrading from V1.3 to V1.2, login to the web interface fails. Resulting in error 500 with
no possibility to go back to V1.3.
Solution:
Don't downgrade to 1.2 software or lower.
4.11 System is not clean after downgrade to previous version and reset to
factory defaults
If you want to downgrade to 1.3 and reset to defaults, follow the following procedure.
1. Execute a reset to defaults in version 1.6 or later
2. Afterwards downgrade to 1.3
3. Now you are able to execute a reset to factory defaults.

4.12 How to connect a wireless device and IP cameras

The CCSD-CUxx, all cameras and the video switcher are connected to a layer 2 switch. A
separate wireless access point is connected to the layer 2 switch to enable a wireless tablet for
controlling the system.
General
The Ethernet port is intended to connect the Control PC, IP cameras and other equipment which is
solely used to operate the CCS 1000 D Digital Discussion System.

4.13 Switch microphone off when not used

Switch microphone off when not used for 30 seconds does not work when:
1) Voice mode or PTT mode is selected
2) The device is in chairperson mode
3) The microphone was switched on before this setting was enabled, these devices are
excluded until they are switched off and on again
4) Less than 3 devices with an inactive microphone
Bosch Security Systems| 2022-04-13
6