Mini Pci Board; Power Switch Board - NEC VERSA UltraLite Service And Reference Manual

Mini PCI Board

Remove the Mini PCI LAN/modem board as follows.
Save any open files, exit Windows, turn off notebook power, close the LCD panel, unplug
1.
the power cable, and disconnect any peripheral devices.
Remove the secondary battery, hard drive cover, keyboard, and top cover assembly.
2.
Unplug the Mini PCI board cable from connector P34 on the communication board and the
3.
Mini PCI board cable from connector P43 on the USB connector board (see the following
figure).
Remove the two screws securing the Mini PCI board to the communication board.
4.
Unplug the PCI board from connector P32 on the communication board.
5.
Remove the Mini PCI board from the base.
6.
A – Mini PCI Board Cable Connector P34
B – CMOS Battery
C – Main Board Cable Connector P41
D – USB Connector Board
E – Mini PCI Board Cable Connector P43
F – Communication Board

Power Switch Board

Remove the power switch board as follows.
Save any open files, exit Windows, turn off notebook power, close the LCD panel, unplug
1.
the power cable, and disconnect any peripheral devices.
Remove the secondary battery, hard drive cover, keyboard, and top cover assembly.
2.
Unplug the signal cable from connector P5 on the power switch board (see the previous
3.
figure "Removing the Mini PCI board" for board and connector locations).
Carefully lift the power switch board out of the base.
4.
You might need to flex the side of the base to release the board.
Use care to prevent loss of the plastic power slide switch between the hard drive bay and the
side of the base.
3-10 Disassembly and Reassembly
Removing the Mini PCI board
G – Mini PCI Board
H – CMOS Battery Connector P36
I – PCI Board Connector P32 (under board)
J – Power Switch Board
K – Main Board Cable Connector P51