Automatic Feeder Cleaning
If your originals have black streaks or appear dirty after scanning them through the feeder, clean the rollers of the feeder.
•
It takes approximately 20 seconds to clean the feeder.
•
Feeder Cleaning cannot be performed during printing.
1
1
Press
2
Place 10 sheets of blank paper into the feeder → press [Start] .
Make sure that you fan the sheets of paper well.
Use normal LTR paper.
When cleaning is complete, try scanning again.
To cancel feeder cleaning while it is in progress, press [Cancel].
Wire Cleaning
If streaks appear on printed output or random parts of the printed image are missing, clean the corona assembly wires inside the
main unit.
•
It takes approximately 35 seconds to clean the wire.
•
Wire cleaning cannot be performed during printing.
1
Press
2
Press [Start] .
When cleaning is complete, try printing again.
Roller Cleaning
If dirt or streaks appear on printed output, clean the roller inside of the main unit.
•
It takes approximately 20 seconds to clean the roller.
•
Roller cleaning cannot be performed during printing.
1
Press
2
Press [Start] .
When cleaning is complete, try printing again.
1-72
Routine Cleaning
(Settings/Registration) → [Adjustment/Maintenance] → [Maintenance] → [Clean Feeder] .
(Settings/Registration) → [Adjustment/Maintenance] → [Maintenance] → [Clean Wire] .
(Settings/Registration) → [Adjustment/Maintenance] → [Maintenance] → [Clean Roller] .