Gas Supplg Locations - GE Monogram ZGU385N Installation Instructions Manual

Installation Preparation
POWER SUPPLY LOCATIONS
Gas supply:
These cooktops are shipped from the factorg set
for either natural gas or LP gas. Check to be sure
SOU have the correct cooktop for the tgpe of gas
being used.
• The pressure regulator must be connected in series
with the manifold of the cooktop and must remain
in series with the supplg line regardless of tgpe of
gas being used.
• The natural gas model is designed to operate at
S" water column pressure. A regulator is required
at the natural gas source to provide a minimum
of 6" water column to the cooktop regulator.
• The liquid propane model is designed to operate at
!0" water column pressure. A regulator is required
at the LP source to provide a minimum of :!1" water
column to the cooktop regulator.
Maximum inlet pressure for the regulator supplied
with the cooktop is 14" water column regardless of
the gas being used.
For ease of installation, and if local codes permit,
the gas supplg line into the cooktop should be 1/2"
or 3/4" ID flexible metal appliance connector, three
to five feet long.
NOTE: Purchase new flexible line. DO NOT USE OLD,
PREVIOUSLY USED FLEXIBLE LINE.
• Make gas connection through rear wall, or on
cabinet floor at rear, as illustrated.
1. Install the house gas supplg at least !" from
the back wall.
2. Locate the electrical outlet !2" below the
countertop.
Gas
supply
line
Install a manual shut-off valve in the gas line in an
easilg accessible location outside the cooktop. Be
sure SOU know how and where to shut off the gas
supplg to the cooktop. Install the electrical outlet
!2" below the countertop.
Electrical supplg:
This cooktop features pilotless electric ignition for
energg savings and reliabilitg. It operates on a 120 volt,
60 Hz power supplg. A separate circuit, protected bg a
!5 amp time delag fuse or circuit breaker, is required.
Optional Combination Installations
This cooktop mag be installed in combination
with a ZVB36 Monogram Downdraft Vent, a ZET1
or ZET938 Single Oven or a ZTD910 or ZKD910
Warming Drawer.
• The gas and electrical supplg must be located
where it will not interfere with vent housing, the
oven or the warming drawer. Review pages 12
to 14 for additional installation requirements.
• A properlg-grounded 3-prong receptacle should
be located within reach of the cooktop's four-foot
power cord.
IMPORTANT: (Please read carefully). FOR PERSONAL
SAFETY, THIS APPLIANCE MUST BE PROPERLY
GROUNDED.
The power cord of this appliance is equipped with
a three-prong (grounding) plug which mates with a
standard three-prong grounding wall receptacle to
minimize the possibilitg of electric shock hazard
from this appliance.
The customer should have the wall receptacle and
circuit checked bg a qualified electrician to make sure
the receptacle is properlg grounded and has correct
polaritg.
Where a standard two-prong wall receptacle is
encountered, it is the personal responsibilitg and
obligation of the customer to have it replaced with
a properlg grounded three-prong wall receptacle.
Do Not, Under Any Circumstances, Cut Or Remove
The Third (Ground) Prong From The Power Cord.
Do not use an extension cord.
8