GE Monogram ZGU385N Installation Instructions Manual page 10

Installation Instructions
141 ASSEMBLE BURNERS,
CHECK IGNITION
The electrode of the electronic ignition sgstem
is positioned above the surface of the burner
base. Do not remove a burner cap or touch the
electrode of a burner while another is turned
on. Damage or electrical shock mag occur.
A. Remove tape holding burners in position. Note
the position of one larger burner base, head and
cap. The large and regular size pieces are not
interchangeable.
B. Place burner heads over the burner base.
Make sure the hole in the burner head is properlg
aligned with the electrode in the burner base.
Burner cap
<>
Burner head _
assembly
Burner
Electrode base
C. Place the burner caps on the burner heads.
Make sure that the burner caps are properlg
seated on the burner heads.
Burner cap properly seated
Burner cap not properly seated
[] ASSEMBLE BURNERS,
CHECK IGNITION (cont.)
D. Check igniters.
Operation of the electric igniters should
be tested after the cooktop and supplg line
have been carefullg checked for leaks and the
cooktop has been connected to the electrical
power.
• Push and turn a burner valve to the LITE
position. All spark igniters will make a series
of sparks (ticking sounds), but onlg the burner
turned to LITE will light.
- The burner should light when gas is available
to the burnen
- Once the burner lights, it should be turned to
another position.
• Test each valve separatelg until all burners have
been checked.
IMPORTANT: If the igniter electrodes continue to
spark after all of the burners are lit, check that
each burner component is assembled and
properlg seated.
E. Burner ignition.
Cooktop Spark Ignition-When gou turn the
cooktop knob to LITE, the spark igniter makes
a series of electric sparks (ticking sounds) which
light the burner. During a power failure, the
burners will not light automaticallg. In an
emergencg, a cooktop burner mag be lit
with a match bg following the steps below.
WA RN IN
G" Lighting gas
burners with
a match isdangerous.You should match light
the cooktop burners onlg in an emergencg.
• Light a match and hold the flame near the
burner Uou want to light. Wooden matches
work best.
• Push in and turn the control knob slowlg.
Be sure gou are turning the correct knob
for the burner gou are lighting.
NOTE: If the burner does not light within five
seconds, turn the knob off and wait one minute
before trging again.
10