Kenmore 79053 Service Manual page 37

• MODEL: 79184/79188
3.5 HOW TO INSTALL
1. Remove the screws which fasten the cabinet at
the back and side of the unit.
2. Slide the unit out of the cabinet by gripping the
base pan handle and pull forward while bracing
the cabinet.
3. Cut the Foam-PE (_ to fit the underside of the
window sash. Peel off the backing and attach the
Foam-PE as shown in Figure 102.
Figure 100
Figure 101
4. Insert the side curtain (_ into the upper guide and
lower guide of the air conditioner. Fasten the cur-
tains to the unit with TYPE A screws @.
Figure 102
(TYPEA)
5. Open the window. Mark a line on the center of the
window stool between the side window stop mold-
ings. Loosely attach the sill bracket to the supped
bracket using the carriage bolt and the lock nut.
6. Attach the sill bracket to the window sill using the
TYPE B screws ®. Carefully place the cabinet on
the window stool and align the center mark on the
angle front with the center line marked on the win-
dow stool.
7. Using the M-screw ® and the lock nut _), attach
the support bracket to the cabinet track hole. Use
the first track hole after the sill bracket on the out-
er edge of the window sill. Tighten the carriage
bolt and the lock nut. Be sure the cabinet slants
outward 1/4 bubble using the carpenters level.
CAUTION: Do not drill a hole in the bottom pan. The
unit is designed to operate with approxi-
mately 1/2"of water in bottom pan.
Figure 103
Sill
bracket
Cardage
bolt
Figure 104
Cabinet
track hole
bracket
Carriagebolt
andlock nut
Figure 105
Upper guide-_-
Figure 106
) (TYPEA)
bracket
• _ Lock nut
Machinescrew
locknut
Outer
edgeof
window sill
®
Sill
_/_/__LSide window stop
_ molding
l Window too,
---37--