Kenmore 79053 Service Manual page 17

2.6.3 FAN, SHROUD
1. Remove the cabinet. (Refer to section 2.5.2)
2. Remove the 4 screws which fasten the condenser,
3. Move the condenser sideward carefully.
4. Remove the clamp which secures the FAN with a
hand plier.
5. Remove the FAN,
6. Remove the SHROUD.
7. Re-install by referring to the removal procedure.
Figure 28
2.7 ELECTRICAL PARTS
2.7.1 OVERLOAD PROTECTOR
1. Remove the cabinet. (Refer to section 2.5.2)
2. Remove the nut which fastens the terminal cover.
3. Remove the terminal cover.
4. Remove all the leads from the overload protector.
5. Remove the overload protecto_
6. Re-install the component by referring to the above
removal procedure.
Figure 29
2.7.2 COMPRESSOR
1. Remove the cabinet. (Refer to section 2.5.2)
2. Discharge the regdgerant system using a
Freon
TM
Recovery System.
If there is no valvo to attach the recovery system,
install one (such as a watco a-l) before venting
the Freon
TM
Leave the valve in place after
servicing the system.
3. Remove the ovedoad protector. (Refer to section
2.7.1)
4. After purging the unit completely, detach the suc-
tion and discharge tube at the compressor con-
nections.
5. Remove the 3 nuts and the 3 bracket washers
which fasten the compressor.
6. Remove the compressor.
7. Re-install the components by referring to the
removal procedure, above.
Figure 30
Figure 31
Figure 32
m17--