Kenmore 79053 Service Manual page 24

2.11.7 MOTOR
1. Remove the cabinet. (Refer to section 2.9.2)
2. Remove the evaporator.
3, Remove the orifice. (Refer to section 2.10,1 )
4. Remove the blower. (Refer to section 2.10.1)
5. Remove the fan. (Refer to section 2.10.2)
6. Remove the control box cover and disconnect 5 or
4 wires of motor housing. (Refer to section 2,9.3)
7. Remove the 4 screws which fasten the motor from
the mount motor. (See Figure 54.)
8. Remove the motor.
9. Re-install the components by referring to the
removal procedure, above.
2.12 REFRIGERATING CYCLE
Figure 54
Discharge the refrigerant system using a
Freon
TM
Recovery System.
If there is no valve to attach the recovery
system, install one (such as a WATCO A-l)
before venting the Freon
TM.
Leave the valve in
place after servicing the system.
2.12.1 CONDENSER
1. Remove the cabinet• (Refer to section 2.9.2)
2. Remove the 4 screws which fasten the
• brace.(Refer to section 2.10.1)
3. Remove the 5 screws which fasten the condenser
and shroud.
4. After discharging the refrigerant completely,
unbraze the interconnecting tube at the condenser
connections.
5. Remove the condenser.
6. Re-install the component by referring to notes•
2.12.2 EVAPORATOR
1. Remove the cabinet. (Refer to section 2.9.2)
2. Remove the 2 screws which fasten the evaporator.
3. Move the evaporator sideways carefully.
(Refer to section 2.10.1)
4. After discharging the refrigerant completely,
unbraze the interconnecting tube at the evapora-
tor connections.
5. Remove the evaporator.
6. Re-install the component by referring to notes.
2.12.3 CAPILLARY TUBE
1. Remove the cabinet. (Refer to section 2.9.2)
2. After discharging the refrigerant completely,
unbraze the interconnecting tube at the capillary
tube.(See caution above)
3. Remove the capillary tube.
4. Re-install the component by referdng to notes.
Figure 55
Figure 56
---24---