Cisco CiscoWorks Wireless LAN Solution Engine Installation And Configuration Manual page 94

Setting Up IOS Access Points
Step 9
Note
Using a WLSE Configuration Template to Configure WDS Access Points
Step 1
Step 2
Step 3
Step 4
Installation and Configuration Guide for the CiscoWorks Wireless LAN Solution Engine
5-16
The WDS access point must also register and authenticate itself to the WDS to
participate in the SWAN hierarchy; therefore, the WDS AP is also an
infrastructure AP. To configure the WDS access point as an infrastructure access
point:
wlccp ap username username password password
To configure authentication for wireless clients, see the relevant AP
documentation.
You can use the WLSE to configure one or more WDS access points.
The major configuration steps are:
Create a configuration template to set up AAA servers and the WDS.
•
Apply the configuration template to the appropriate access points by running
•
a configuration job.
To configure WDS access points by using a WLSE configuration template:
Log in to the WLSE web interface.
Select Configure > Templates.
Enter a template name, selecting IOS as the template type.
a.
Click Create New.
b.
Enter the AAA servers for LEAP authenticating the infrastructure access points
and the WLSE to the WDS, and the AAA servers for authenticating wireless client
devices:
Select Security > Server Manager.
a.
In the Corporate Servers section, for each server, enter the IP address, select
b.
RADIUS, and enter the shared secret.
Click Save.
c.
Select Wireless Services > WDS to configure the WDS parameters.
Chapter 5 Setting Up Devices—CiscoWorks 1105/1130/1130-19
78-16345-01