Input Signal (For Pc Input Mode); Digital Noise Reduction; Language; Speaker Setup - Sharp Aquos LC-32G4U Operation Manual

Useful adjustment settings

Input signal (for PC input mode)

• Some input signals may have to be registered manually
to display properly.
• The pairs of input signals (resolutions) in the list below
are not distinguishable when received. In such case, you
have to set the correct signal manually. After setting once,
it will display when the same signal (resolution) is input
again.
640g400
640g480
1024g768
NOTE
• You can only select the "Input Signal" on the Setup menu
when receiving one of the 6 input signals listed above.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Setup".
3
Press a/b to select "Input Signal" and then
press ENTER.
[ Setup ... Input Signal ]
MENU
Setup

Speaker Setup

Input Signal

Auto Sync.

Input Label

Fine Sync.

Picture Flip

Language

4
Press a/b to select the desired input signal
on the display.
720g400
848g480
1280g768
Option
[848 x 480]
[INPUT 1]
[Standard]
[English]
Example
640 x 480
848 x 480

Digital Noise Reduction

Produces a clearer video image.
1
Press MENU and the MENU screen displays.
2
Press c/d to select "Option".
3
Press a/b to select "Digital Noise
Reduction", and then press ENTER.
[ Option ... Digital Noise Reduction ]
MENU
Option

Audio Only

Digital Noise Reduction

Input Select

Output Select

Quick Shoot
Center Channel Input
Caption Setup
4
Press a/b to select the desired level, and
then press ENTER.
[Low]
[Auto]
[Fixed]
[Off]
[Off]
Off
High
Low
73