Setting The Avc System With The Stand - Sharp Aquos LC-32G4U Operation Manual

Preparation

Setting the AVC System with the stand

How to install the AVC System vertically using the stand unit.
• Use the supplied stand unit for installing the AVC System vertically in an upright position.
Stick each spacer to the
1
stand as shown.
Peel each spacer away from the paper
and attach to the four bulging areas
on the stand.
Stand
spacer
Bulge
Bulge
Attach the stand using the
4
stand screws as shown.
NOTE
• When mounting the AVC System vertically, always use the supplied stand. Be careful not to block vent holes when
standing up directly on the floor or a flat surface as this can result in equipment failure.
Bottom view
Attach each cushion to
2
the stand as shown.
Peel each cushion
away from the
paper and attach
to the four areas
at the bottom.
Attaching point
The AVC System installed
vertically with the stand.
Stand screw
Fit the stand to the AVC
3
System.
Insert the stand into the AVC
System, making sure that the
thick and thin bulges of the
stand align with the big and
Stand cushion
small holes on the AVC
System.
Attaching point
The name plate is attached on the bottom
of the AVC System. Confirm it if necessary.
Bulge
Hole
13