Makita 9300 Instruction Manual page 12

5. Keep
a
clearance of approximately 2mm
(3/32") between the wheel and the
blade teeth for turning. Secure thumb
screw.
Next, draw blade up to wheel
so
that
the wheel is well into the tooth gullet.
Use adjust screws (B, C) for fixed
set-
ting that will assure uniform gullet
depth when sharpening.
I
Y
6. To obtain the original bevel angle or an
angle of 15 degrees, release the thumb
screw below on the inclining
tool
rest.
Tilt rest to desired angle and secure with
thumb screw.
Now proceed to sharpen blade by grind-
ing every other tooth.
After sharpening on side, readjust inclin-
ing tool rest for the same angle for the
opposite-side teeth. Turn blade over
after releasing
set
nut;
set
blade on
blade holder and secure with
set
nut.
Sharpen the other side of the blade (i.e., every other
as
yet unsharpened tooth) using
the same procedure indicated above.
12