Makita 3612B Instruction Manual page 6

Stopper block
.The stopper block has an adjustment hex
bolts which move 1 mm (1/32") per turn.
After obtaining the desired depth setting,
tighten the hex nut on the bolt with the
spanner.
\
block
I
Nylon nut
By turning the nylon nut, the upper limit
of the tool can be adjusted. When the tip
of the bit i s retracted more than required
in relation to the base plate surface, turn
the nylon nut to lower the upper limit for
more effective routing.
CAUTION :
0
Do not lower the nylon nut too low or the bit will dangerously protrude.
0
Before operating the tool, check to be sure that the router automatically rises to the
upper limit.
Switch action
*To start the tool, position the switch
lever
t o
"ON" side.
To
stop, to "OFF"
side.
CAUTION
Prevent accidental starting by making
sure the tool
is
switched off before you
plug it in.
Switch lever
6