Maintenance - Makita 3612B Instruction Manual

MAINTENANCE
CAUTION :
Always be sure that the tool
is
switched off and unplugged before attempting to perform
inspection and maintenance.
Replacing carbon brushes
0
Remove and check the carbon brushes
regularly. Replace when they wear down
to about
6
mm (1/4") or less. Keep the
brushes clean and free to slip in the
holders. Both brushes should be changed
a t the same time. Use only Makita carbon
brushes.
0
Use a screwdriver to remove the brush
holder cap as shown on the figure.
.Take out the worn brush, insert the new
one and secure the brush holder cap.
k 4
6 mm (1 /4")
BNSh holder cap
Any other maintenance should be performed by an Authorized Makita Service Center or
point of purchase.
10