Makita 3612B Instruction Manual page 5

Installing
bit
0
Loosen the collet nut and insert the bit
into the chuck hole. Press the shaft lock
and use the wrench to secure the bit care-
fully. Use the collet sleeve if necessary.
I
CAUTION :
0
Do not tighten the collet chuck without inserting a bit; do not install a small bit with-
out using
a
collet sleeve. Either can lead t o collet chuck breakage.
Adjusting cutting depth
Release the lock lever and lower the tool
to the desired depth. Then pull up on the
lock lever to lock. Now adjust the stopper
block and pole so that, even if the lock
lever
i s
released, the router stops
a t
the
uniform depth.
If you press the fast-feed button on the
stopper pole, the pole can be advanced
rapidly. Ordinarily the pole moves 1.5 mm
(1/16") per turn. Minute depth adjust-
ments can be obtained by raising or
lowering the stopper pole.
5