Mitsubishi WS-A48 Owner's Manual page 27

Part II1: Setup
Use of the Remote Control with Other A/V Products
[]
Figure 4. Programming the remote to control your DVD/
LDP.
After entering the correct codes in each
position of the remote control, use the slide
switch to select which product will respond
when an operational button is pressed. If you
enter a code from the AUDIO chart while the
slide switch is set to TV, the volume and mute
functions change to match the A/V receiver.
This is useful when using an A/V receiver with
the TV all the time. In all other cases, only
one of the below devices is allowed for each
slide switch position.
TV position:
III
-_ TV
..,"_ A/V receiver (volume and mute only)
Cable/DBS/DTV position:
Cable box
Satellite receiver
DTV receiver
VCR position:
VCR
DVD position:
DVD
LD Player
Figure 5. Programming the remote to control your A/V
receiver.
Audio position:
A/V receiver
Mitsubishi CD player
If you have a Mitsubishi A/V receiver, the
audio position may be used in conjunction
with select Mitsubishi CD players. Your audio
position must be programmed to either 010
or 011. Plug the CD player power cord into
a switched outlet on the back ofyourA/V
receiver, Pressing the POWER button tums
On the A/V receiver, along with the CD player.
In the audio position, for some CD players,
the transport controls (FF, Play, Rew, etc.)
operate the CD player.
+i+i#i_
ii!i!i!ii!
iii!i_i!_ii
iiii!!
iiii!ii!_ !++
iiii!iiiiiiiii+
iii iiiii_i#iiii#!i .....