Mitsubishi WS-A48 Owner's Manual page 21

Part I1: Installation
Connecting a DTV Receiver
DTV Receiver with RGB Video
Connections
(Figure 1)
Figure 1. Connecting the DTV receiver with RGB video
connections.
[]
Connect the outside antenna, cable, or
satellite to ANT or SATELLITE IN on the
DTV receiver (see your DTV receiver's
owner's guide for instructions and cable
compatibility).
[] Connect the incoming terrestrial antenna
or cable (not satellite) to ANT-A on the
TV back panel (a coaxial splitter, available
at most electronic supply stores, may be
required to complete this installation).
Connect the RGB cables from the DTV
receiver to the TV back panel as listed
below (if your DTV receiver uses BNC-type
cables, use the adaptors shown in
Figure 1, page 20):
DTV Receiver TV Back Panel
_L_ G (green) = Y
B (blue) = Pb
[] R (red) = Pr
If the DTV receiver has outputs for H
and V sync, connect as listed below (DO
NOT connect if DTV receiver uses "Sync
on Green"):
H (horizontalsync) = H
V (vertical sync) = V
[]
m
Connect the L (left) and R (right) audio
cables from the DTV receiver and to DTV
AUDIO on the TV back panel.
To utilize the benefits of a digital
A/V receiver, connect your DTV receiver's
digital audio out to a digital input on your
digital A/V receiver.
You may need to setup the DTV (See Input
Assignment, page 31) to RGB.