Installthe Light And Lens; Attach Emergency Release Rope And Handle - Craftsman 139.53225SRT1 Owner's Manual

Installation Step 7
Install the Light and the Lens
Install the Ilghta
• Install a 75 watt maximum light bulb in the socket.
The light Jill turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the light will turn OFF.
• If the bulb bums out prematurely due to vibration,
replace it with a standard neck "Garage Door
Opener" bulb.
Install the lens
(except for Model 53225)
• Apply slight pressure on the sides of the lens and
slide the tabs into the slots in the end panel.
• Reverse the procedure to remove the lens.
I
Lens Guide
Ught
Installation Step 8
Attach the Emergency Release
Rope and Handle
Overhand
Knot
Rope
Emergency
Overhand
Knot
Do not use the red handle to pull the door
open or closed. The rope knot could become
untied and you could fall. Usa the emergency
release only to disengage the trolley end, If
possible, only when the door Is closed.
Garage doors are heavy. If the door Is open
when the handle Is pulled, the door could
close inadvertently If It is not properly
balanced. Sedous Injury may result to persons
under the door. Make sure the doorway is clear
of persons end obstructions before pulling
handle when door is open.
• Thread one end of the rope through the hole in the
top of the red handle so "NOTICE" reads fight side
up as shown. Secure with an overhand knot.
The imot should be st least 1 • from the end of the
rope to prevent slipping.
• Thread the other end of the rope through the hole in
the release ann of the outer trolley.
• Adjust rope length so the handle is 6 feet above the
floor. Secure with an overhand knot.
ff it Is necessary to cut the rope, heat seal the cut
end with • match or lighter to prevent unraveling.
19