Install The Wall Control - Craftsman 139.53225SRT1 Owner's Manual

Installation Step 6
Install the Wall Control
• Strip 1/4" of insulation from one end of the bell
wire; connect the wire to the two screw terminals
on the back of the Wall Control: white to 2 and
white/red to 1.
• Locate the Wall Control within sight of the door
at a minimum height of 5 feet where small
children cannot reach, and away from all
moving parts of the door and door hardware.
Fasten the Ughted Push Button Wall Control
securely with 6ABx1-1/2" screws. The console
style uses 6ABxl" screws. If installing into drywall,
ddll 5/32" holes and use the anchors provided.
• Run the bell wire up the walt and across the ceiling
to the opener. Use insulated staples to secure the
wire in several places. Be careful not to pierce the
wire with a staple, thereby resulting in a short.
• Receiver terminal screws and the antenna are
located on the back panel of the opener. Position
the antenna wire as shown.
• Then connect the hell wire to the opener terminal
screws: white to 2; white/red to 1.
• Remember to affix the User Safety Instruction
label to the wall near the Wall Control, and the
Maintenance Instruction label in a prominent
iocstlon on the Inside of the garage door.
If the label adhesive will not adhere to your garage
wall surface (or becomes loose with time) use tacks
to secure the label alongside the wall control.
Page 32 explains how to operate the opener using
the lighted push bar or button, as well as the Lock
and Ught features on the Deluxe Wall Control.
Hardware Shown Actual Size
_ lllll,ltlillltl#lllllllllllll_l_>
6AS x 1-1/2" Sorew
Ughmd P InkBuaen W a= C,:m_
insulated _
6ABx 1" Sinew
Lighted Console WaS Cam_
Dry Walt Anchors
I
Children operating or playing with a garage
door opener can Injure themselves or others.
The garage door could close end cause serious
Injury or death.
Install the Wall Control (or any additional push
buttons) out of the reach of children and away
from all moving parts of the door and door
hardware, but where the garage door is visible.
Do not allow children to operate the push
button(a) or the remote control(s).
A moving garage door could Injure someone
under It. Activate the opener only when the
door is properly adjusted, you can see it clearly,
and there are r_oobstructions to door travel.
Do NOT.connect the power and operate the
opener at this time. The trolley will travel to the
full open position but will not return to the
close position until the sensor beam Is
connected end properly aligned.
See Safety Reversing Sensor Instructions
beginning on page 21.
Outdoor Key Switch Accessory Connections
To Opener terminal screws: white to 2; white/red to 1
Lighted Push Button
Wall Control
Deluxe Wall Control
Lighted Console Wall Control
Terminal Screws TopInstallation
Range
Bottomln41tallation
Range
BackPanel
of Opener
18