Operation Of Your Opener - Craftsman 139.53225SRT1 Owner's Manual

Operation of Your Opener
Aotlva_ the opener v_lh any of the fullowing:
1. The Remote Control
• 3-FuncUon and C_mpact: Hold large push
button down until the door starts to move.
• Single function: Hold push button until the door
starts to move.
2. The Wall Control. Hold push bar or button down
until the door starts to move.
3. The Key Switch or Keylees Entry.
(See Acneesodes)
When the opener is activated with the safety
reversing sensor Installed end correctly aligned:
1. fl opan, the door will close. If cloesd, it will open.
2. If closing, the door will reverse.
3. If opening, the door will stop (allowing space for
entry and exit of pets and for flesh air).
4. If the door has been stopped in a partially open
position, it will dose.
5. If obstructed while closing, the door will reverse.
• 6. If obstmctod white opening, the door will stop.
7. The garage door wil reverse in the dosing cycle when
the _ beam is broken. If tully open, the door will
not dose when _ beam is broken. The sensor has
no eftect in the opaning cycis.
If the sensor is not installed or not aligned correctly,
the door won't close from any remote control. You can
close the door with the Wall Control, the Key Switch,
or Keyleas Entry, however, if you activate them until
down travelis complete. If you release them too soon,
the door w_t reverse.
The opener lights will blink for 5 seconds when the
safety reversing sensor causes the door to reverse.
The Opener Lights will tum on under the following
conditions:When the opener is initiallyplugged in; when
the power is intent_ed; when the opener is activated. It
will turn off automatically after 4-1/2 minutes or provide
constant light when the Light feature is activated. Bulb
size is 75 watts maximum.
Weak or broken springs could allow an open
door to fall (either rapidly or unexpectedly),
resulting in serious Injury, death or property
damage. If possible, use the emergency
release rope end handle on/y when the door Is
fully closed.
O' Tmley
@ RW Arm
P, ekwse H and_
(Pu,Down)
Manual disconnect
position
The lockout feature
prevents the trolley
from reconnecting
automatically. Pull the
emergency handle
down and back (toward
the opener). The door
can then be raised and
lowered manually as
often as necessary. To
disengage the lockout
feature, pull the
emergency handle
straight down. The
trolley will reconnect on
the next UP or DOWN
operation.
Operation of the Wall Control
To open the door
manually:
The door should be
fully closed If possible.
Pull down on the red
emergency release
handle and liftthe door
manually. To
reconnect the door to
the opener, press the
Wall Control push bar
or button.
@ F_ease Arm
Emergency
Release Handle
(Pull Down& Back
To*ards Ope_r)
Lockout position
Press the lighted push bar or button to open or
close the door.
Press again to reverse the door during the dosing
cycle or to stop the door while it's opening.
Deluxe Lighted Console (model 53824 only)
Light feature: Press the Light button. If the opener
5ght is off, ;t will tum on.
If the opener light is on, (even in the 4-1/2 minute
automa_ cycle) it will tum off.
BUt if you use the Light button to turn the light on
and then activate the opener, the light will turn off
after 4-1/2 minutes.
The Light button will not control the opener light
when the door is tn too'don.
Lock fsatum: The Lock feature is designed to
prevent operation of the door from portable remote
cotltmls. However, the door will open and close
from the Deluxe Wall Control push bar, the Key
Switch and the Multi-Function Keyisse Entry.
To activate: Press and hold the Lock button for
2 seconds. The push bar light will flash as long as
the Lock feature is on.
To turn off: Press and hold the Lock button again
for 2 seconds.The push bar light will stop flashing.
Normal operation will resume. The Lock feature will
also turn oft whenever the SRT button on the opener
end p_al is activated.
32