Receiver And Remote Controlprogramming - Craftsman 139.53225SRT1 Owner's Manual

Receiver and Remote Control Programming
To comply with FCC rules, adjustment or modificationsof this
receiver and/or transmitter are prohibited,except for changing
the code setting or replacing the battery, THERE ARE NO
o'n.IER USER SERVICEABLE PARTS.
Models with 3-function remote controls: The
remote control(s) has been factory set to operate
with the large push button. However, you can use
either of the two small buttons, if you prefer. And,
the 3-function remote control(s) can also activate
additional garage door openers and/or light controls.
Below are instructions for programming your opener
to match the other buttons on your remote controls
and any additional remote controls you may
purchase. See available accessories on page 38.
Models with a single-function remote control:
The garage door will operate when you press the
remote control push button. Refer to the information
below if you want to add a 3-function remote control
or erase your programmed code.
53000SRT Series Garage Door Openers
(With "SRT" Button)
Your "SR'I" garage door opener will operate with as
many as four "SRT" portable remote controls and
one Multi-Function Keyless Entry.
To-Add A Remote Control
1. Select a remote control push button to operate
the receiver.
2. Press and holdthe selected remote control push
button, Figure 1.
3. Then press and release the "SR'I" button on the
back panel of the opener, Figure 2. The opener
light will flash once.
Now the opener will operate when the remote
conVol push button is pressed.
If you release the remote control push button
before the opener UgM flashes, the opener will
not accept the code.
To Change the Selected Push Button
" On the Same Remote Control
If you decide to use a different remote control button
than originally programmed into the opener, you
need to erase aJlthe leamed codes and reprogram
each remote control used to operate the garage
door opener.
Children operating or playing with s garage
door opener can Injure themselves or others.
The garage door could close and cause
serious Injury or death. Do not allow children
to operate the wall push button(s) or remote
control(s).
A moving garage door could Injure or kill
someone under It. Activate the opener only
when you can see the door clearly, It is free of
obstruCtions, and Is properly adjusted.
Figure I
Single FunCtion
Mini 3-Function Remote Control
Remote Control
Standard 3-Function Remote Control
Figure 2
Garage Door Opener
(With "Smart" Button)
7 V
To Erase All Remote Control Codes
• Press and hold the "SRT" button on the opener
panel until the indicator light turns off (about 6
seconds). AIIthe codes the opener has learned
will be erased.
• To rsprogram, repeat Steps 1, 2 and 3 for each
remote control in use.
Code programming Instructions are also located
on the opener panel.
"SRT" Indicator
Buttoe Light
END PANEL
33