Install The Light And Lens; Attach Emergency Release Rope And Handle - Craftsman 139.53661SRT1 Owner's Manual

For residential use only
Table of Contents

Advertisement

6. Attach the User Safety Instruction label to the wall
neat the door control, and the Maintenance
Instruction label in a prominent location on the
inside of the garage door.
Page 32 explains how to use the door control.
,
r
Do NOT connect
the power
and operate
the
openerat
this time. The trolley will travel to the
full open position
but wilt not return
to the
close
position
until
the
sensor
beam
is
connected and properly aligned.
See Safety
Reversing
Sensor
instructions
beginning on page 21.
Installation
Step 7
Install
the Light
and
the Lens
Install
the light:
• Install a 75 watt maximum light bulb in each
socket. The lights will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the lights will turn OFF.
• If the bulbs bum out prematurely due to vibration,
replace them with standard neck "Garage Door
Opener =bulbs.
Install the lens:
• Apply slight pressure on the sides of each lens
and slide the tabs into the slots in the side panels.
', For convenience,
the lens may be Installed
after Adjustment
Step 4 on page 30.
• Reverse the procedure to remove the lenses.
Installation
Step 8
Attach
the Emergency
Release
Rope
and Handle
I
Do not use the
red handle to pull the door
open or closed.
The rope knot could become
untied and you could
fall. Use the emergency
• Thread one end of the rope through the hole in
release
only to disengage
the trolley
and, if
the top of the red handle so "NOTICE" reads dght
possible, only when the door Is closed.
side-up a_shown.
Secme with an overhand knot.
Garage
doors are heavy. _t the door is open
The knot should be at least 1" from the end of
the rope to prevent slipping.
:• Thread the other end of the rope through the hole
in the release arm of the outer trolley.
• Adjust rope length so the handle is 6 feet above
the floor. Secure with an overhand knot.
If it is necessary to cut the rope, heat seal the
cut end with a ma_ch or lighter to prevent
unraveling.
when the handle
is pulled,
the door
could
close
inadvertently
if it Is not
properly
balanced.
Serious Injury may result to persons
under the door. Make sure the doorway is clear
of persons
and obstructions
before
pulling
handle when door is open.
r
P.ekmseAnn
Rem
Handle
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents