Lan - Draytek VIGOR 3300 User Manual

3 . 2 . 2 L A N
3 . 2 . 2 L A N
In the Network group, select LAN option. The following page for LAN IP/DHCP will be
shown.
F o r L A
F o r L A
In the Vigor3300 Series router, there are some IP address settings for the LAN interface. The
IP address/subnet mask is for private users or NAT users. The IP address of the default
gateway on other local PCs should be set as the Vigor3300 Series' server IP address. When
the DSL connection between the DSL and the ISP has been established, each local PC can
directly route to the Internet. The IP address/subnet mask can also be used to connect to other
private users (PCs). On this page you will see the private IP address defined in RFC-1918.
Usually we use the 192.168.1.0/24 subnet for the route.
IP Address
Subnet Mask
Status
Start IP
End IP
Primary DNS
44
N I P / D H C P
N I P / D H C P
Type the IP address for LAN/DHCP.
Type the subnet mask for the LAN IP/DHCP.
Click Enable the DHCP server; click Disable to close DHCP
server; click Relay Agent to close DHCP sever and do the job
of DHCP server. Corresponding settings for Relay Agent can be
configured in the page of DHCP Relay Agent.
Sets the starting IP address of the IP address pool for DHCP
server.
Sets the ending IP address of the IP address pool for DHCP
server.
Sets the private IP address of the primary DNS.
Vigor3300 Series User's Guide