Makita LS1013 Instruction Manual page 15

In the case of left bevel cut
Table (A)
Molding
position in
52/38˚ type
Fig. A
(1)
For inside
corner
(2)
Left 33.9˚
(3)
For outside
corner
(4)
Table (B)
Molding
Molding edge against
position in
Fig. A
Ceiling contact edge should
(1)
be against guide fence.
For inside
corner
(2)
Wall contact edge should be
against guide fence.
(3)
For
outside
Ceiling contact edge should
corner
(4)
be against guide fence.
Example:
In the case of cutting 52/38° type crown
molding for position (1) in Fig. A:
• Tilt and secure bevel angle setting to
33.9° LEFT.
• Adjust and secure miter angle setting to
31.6° RIGHT.
• Lay crown molding with its broad back
(hidden) surface down on the turn base
with its CEILING CONTACT EDGE
against the guide fence on the saw.
• The finished piece to be used will
always be on the LEFT side of the blade
after the cut has been made.
In the case of right bevel cut
Table (A)
Molding
position in
52/38˚ type
Fig. A
(1)
For inside
corner
(2)
Right 33.9˚ Right 30˚
(3)
For outside
corner
(4)
Bevel angle Miter angle
45˚ type
52/38˚ type
Right 31.6˚
Left 30˚
Left 31.6˚
Right 31.6˚
Finished piece
guide fence
Finished piece
will be on the
Left side of
blade.
Finished piece
will be on the
Right side of
blade.
Bevel angle Miter angle
45˚ type
52/38˚ type
Right 31.6˚
Left 31.6˚
Right 31.6˚
006361
45˚ type
For inside
Right 35.3˚
corner
Left 35.3˚
Right 35.3˚
For
outside
corner
006362
006363
45˚ type
Right 35.3˚
Left 35.3˚
Right 35.3˚
15
Table (B)
Molding
Molding edge against
position in
guide fence
Fig. A
Wall contact edge should be
(1)
against guide fence.
(2)
Ceiling contact edge should
be against guide fence.
(3)
Wall contact edge should be
(4)
against guide fence.
Example:
In the case of cutting 52/38° type crown
molding for position (1) in Fig. A:
• Tilt and secure bevel angle setting to
33.9° RIGHT.
• Adjust and secure miter angle setting to
31.6° RIGHT.
• Lay crown molding with its broad back
(hidden) surface down on the turn base
with its WALL CONTACT EDGE against
the guide fence on the saw.
• The finished piece to be used will
always be on the RIGHT side of the
blade after the cut has been made.
006364
Finished piece
Finished piece
will be on the
Right side of
blade.
Finished piece
will be on the
Left side of
blade.